Magus Tech

In a blink of an eye, several days have passed. During these days, Richard has barely been out of the house and has been busy in the Garden of Eden.

This is bad for Wanan.

In the second floor wooden building.

The wizard Wanan listened to the latest report from his student Maas, frowned deeply, and asked with some annoyance: "So, in the past few days, except for one time he went out to find special gems, he has no other movements. ?"

"Yes." Mas answered honestly.

"Damn it." Wan An whispered, pacing in the room, pacing and muttering to himself, "Shouldn't it, why is this happening suddenly? Is it..."

What Wan An thought of, looked at Mas with his eyes wide open, and asked seriously: "In other words, wouldn't it be you who was exposed and noticed by the other party?"

"This--" Mas hesitated and shook his head vigorously. "Teacher who won't, I have been very careful every time to ensure that he hasn't been found."

"So what's going on?" Wan An shouted, feeling very bad.

Ma Si contracted in the corner and didn't know how to answer. He touched his hungry stomach and quietly took a piece of fish into his mouth, chewing hard.Seeing Wan An looking towards him, he quickly stopped chewing and said, "Teacher, I really don't know."

Wanan glanced at Mas and said, "Okay, go out without knowing, continue to stare at the kid's point, if anything, report to me immediately."

"Oh." Although he was reluctant, Mas responded helplessly and walked out the door.

...

A few days later, in the Garden of Eden, the main laboratory.

A weird-looking instrument was erected and looked roughly like a cracked brass bell.

After Richard adjusted the instrument, he took out the produced metal sheet.Ten centimeters of metal pieces, he made a total of nine pieces, three horizontal and three vertical stitching together, to form a complete mask.

With the 30-cm square mask assembled, the sound of "slap" was stuck in the middle of the instrument, about one meter away from the ground, and locked firmly, and Richard took out another one-centimeter square film- It is nine percent of the mask area.

Put this tiny, photoresist-coated negative film carefully on the lowermost part of the instrument. With a "snap" sound, it also stuck and locked, and Richard began to adjust the lenses located in various parts of the instrument.

The role of the lens is to adjust the propagation of light to ensure that the light of the light source can illuminate the entire mask, shrink after passing through the mask, and then irradiate the tiny negative film at a specific ratio to complete the lithography.

This is a delicate task, and Richard constantly adjusts the test, and has been busy for a long time to complete.

Then Richard took a deep breath and pressed his hands against the sides of the instrument, pressing together.Just listening to the click, the instrument looked like a brass bell cracked from the side, and now the brass bell is closed.

Richard presses on a button outside the "Bronze Bell", the sound of "buzzing" sounds, and starts to evacuate the air inside to ensure that the inside of the instrument is in a vacuum state.

After completing these, Richard checked again to make sure that there was no problem, and reached out and pressed a button on the top of the instrument, which was the light source switch.

"Slap!"

The light source is turned on, the current chip-like lithography in the medieval world is officially started!

Through the transparent panel of the specific part of the instrument, you can see that the interior looks bright, but in fact there is no change, just an illusion.

Because, the light source emits not visible light.

In general, the eyes of normal humans can perceive the wavelength of light between 400 and 760 nm, and a few more sensitive people can extend the range to between 380 and 780 nm.

Now the light source emits deep ultraviolet light with a wavelength of 200nm to 350nm, which is completely out of the visible range and cannot be seen by the naked eye.

This deep ultraviolet ray has a special energy response and is widely used on the earth for air sterilization in water purification plants, hospitals, and factory dust-free workshops.Now the inside of the instrument is evacuated, and the deep ultraviolet light eliminates the reaction with air and can be directly used for lithography.

In fact, if the extreme ultraviolet between 10nm and 14nm is used for lithography, the effect is better. This is the technology of the fifth generation lithography machine on the earth.However, considering the difficulty of implementation and the fact that it is only an attempt at fulfillment, Richard is not so complicated. He is ready to upgrade the technology a little bit after achieving certain results.

In Richard's gaze, the lithography machine was running stably. Invisible light beams passed through the mask and lens, and concentrated on a one-centimeter square film.

There is no interleaving, no confusion, and the invisible light still strictly follows the physical theorem of linear propagation, accurately projecting the pattern of the mask onto the substrate, and reacting with the photoresist applied on the surface.

At this moment, the invisible light constitutes the most precise knife-the light knife.

They use nanometers or even smaller lengths as the standard unit, and move back and forth in the photoresist silently, allowing the projected pattern to be fixed a little bit and formed a little bit.

There was no sound, no movement, no glory during the whole process-neither visible nor audible.But the change is indeed going on, and eventually, as expected, the film has become a qualified chip.

There was no prayer to gods, no ancestors' protection, no unknown mysterious power came, and the only thing that really existed was technology—the power of technology.

...

For a long time...

"Ding! Ding! Ding!"

A green indicator light on the lithography instrument flashes, indicating that the lithography is completed. Richard carefully opens the instrument, removes the chip, and then puts it in another assembled instrument aside, and begins to rinse with the developer solution to let the photoresist on The pattern is fully visible, followed by a series of subsequent processing.

In the end, Richard got a standard spell chip.

A thin magic chip the size of a fingernail was placed on the fingertips by Richard, and he was carefully observed.After a moment of thought, an extremely fine element of free energy poured out of the spell source and poured into the spell chip.

"Buzz!"

Richard clearly felt that the chip had obvious mana fluctuations and reverberations, which obviously played a role.However, because there are too few free energy elements to be injected, the effect disappears invisible before it can be demonstrated.

Richard’s eyes brightened, and the reaction of the spell chip fully demonstrated that his previous plans, conjectures, and experiments were correct. The “gloom of the world” can be made with the help of chip technology on earth.

Then the next step is... continue to make.

This chip at the fingertips involves a magic pattern that is only about one-tenth of the total magic pattern of "Ecstasy Gloves". If you really want to make "Ecstasy Gloves", then nine more are needed.

nine!

...